|
Great Looking, and Qualty, July 19, 2012
These are well made and look great on your car. I found it a lot easier to remove the tire and wheel before installation. If you use a floor jack as I did. Don't jack up the car in the same spot as the jack that comes with the car. Look for the same spots they would use a floor host on to lift the car. The splash guards don't have to be removed for installation, Just remove the top screw so it makes it easier to install the Plastic Tap and Metal "U" Clip, then reinstall the screw. Each fender only have one spot where you use two of the Plastic Taps. But if you use two of them in the other spots as I did. Black Electrical tap works well as an alternative. This isn't to bad of a job to do. And you will be prod of yourself when the job is done and you have saved yourself $200.00 dollars or more over dealer installation.
By Bill B. from N.W. Ohio
|
|
Car has optional splash guards, March 12, 2012
Have read instructions and it appears I will have to remove the splash guards. Has anyone else had this problem. Fit and finish seem to be excellent, just this matter of removing and reinstalling the splash guards.
By Theram from central kentucky
|
|
It's not that bad!, October 26, 2011
The key thing I found out was to read and understand the instructions before you every think about tackling the job. Give yourself plenty of time (I used 2+ hours on a nice Sunday afternoon). Understand how the clips work and like previously stated use a small screw driver to help pry them apart when installing. The first fender well will take you the longest and the last one will be a breeze. The warmer the day the more pliable the material is. The parts fit well, and I even impressed myself with the job I did!!
By NC mountain Suby owner from Hendersonville, NC
|
|
Breeze, April 10, 2011
If you have any skill level these are very easy to install. Read the directions closely and understand them. Assemble the clips and make sure they are snaped then pry open with a thin flat screw driver and install. Drilling is very easy You only have to go through plastic, turn wheel in before you drill. Go for it
By Subie from NJ from South Jersey
|